Skip to main content

Decommissioning an IPsec Parameter

This page explains how to decommission an IPsec Parameter using the OCX Portal.

Important Notice​

  1. For the following XaaS Connection, configuring an IPsec Parameter is mandatory.
    Deleting the IPsec Parameter will cause a service interruption, so please proceed with caution.

Preparation​

Before decommissioning an IPsec Parameter, please confirm the following:

  1. Your User Role is either admin or user.
  2. The target XaaS Connection resource is in either the available or attached state.

Procedure for Decommissioning an IPsec Parameter​

  1. Log in to the OCX Portal.

  2. From the left navigation bar, click [XaaS Connections].

  3. From the XaaS Connections list page, click the target XaaS Connection resource.

  4. In the lower half of the screen, click the [IPsec Parameters] tab.

  5. When the IPsec Parameter list is displayed, click the Delete icon in the Actions column on the right side of the IPsec Parameter you want to decommission.

  6. A delete confirmation pop-up will appear.
    Enter the pre-shared key, review the notes, check the [I have confirmed.] checkbox, and then click [Delete].
    To cancel the operation, click [Cancel].

  7. Confirm that the target IPsec Parameter has been removed from IPsec Parameters.

    • The status of the XaaS Connection resource will change to updating, and the deleted IPsec Parameter will be shown as “Deleting”.
    • Please note that deletion may take some time to complete.
    • You can refresh the status by clicking [Refresh] in the upper-right corner.

This completes the deletion of the IPsec Parameter.